Very Rare vintage MIP 4WD RC10 with MIP IRS. This buggy was built using some of the rarest MIP parts including the 4 wheel-drive conversion and rear trailing arm suspension (IRS).
The buggy has an "A" stamp chassis with very minimal wear or marks and was carefully modified as per the MIP instructions, as well as the stock front shock tower. Both the front and rear transmissions spin smoothly with no binding or noise and the drive belt is in in good condition.
The axles are stock RC10 cvd's. The tie-rods are a combination of Edinger RC10 and Tecnacraft pieces. The aluminum wing is vintage Tecnacraft as well. The alloy wheels are in excellent condition but had to be modified to fit the RC10 axles, there is a small amount of play because of this. It includes a Novak 1 esc, Novak NER-2x receiver, and a Novak NES-1A steering servo.A Blue label Associated motor (Edinger) was installed when the car was built. An era-correct controller is included as well (not shown). The following NOS parts were used for this build: front MIP steering spindles, NES-1A steering servo, motor, spur gear w/ cover, Andy's body. Other parts used for the build including the MIP 4wd conversion and MIP rear suspension were lightly used. The buggy has been tested since being built, but that's about it.
If you are going to run this buggy, it will likely need minor tuning/ adjustments. Please look at the pics closely. I do my best to describe the items as accurately as possible.. This item is in the category "Toys & Hobbies\Radio Control & Control Line\RC Model Vehicles & Kits\Cars, Trucks & Motorcycles".The seller is "brtrains-n-hobbies" and is located in this country: US. This item can be shipped worldwide.